No products in the cart.
-
- Efficient weather monitoring for optimal irrigation management
- Seamless integration with Modbus TCP communication protocol
- Reliable and trusted brand: Hunter Weather Station
Hunter WS-360-TCP Weather Station with Modbus TCP Communication (WS360TCP)
$4,699.00$4,699.00Add to cart -
The Soil Moisture Sensor Decoder, model CS-2W-MOIST, measures the volumetric water content, temperature, and electrical conductivity of the soil. It also operates a single valve, eliminating the need for an additional Station Decoder.
Calsense CS3000 Soil Moisture Sensor Decoder (CS-2W-MOIST)
$1,449.00$1,449.00Add to cart -
- No straight-pipe requirement! Place immediately after a bend or valve, even in the same valve box (Jumbo size valve box recommended for easiest fit)
- Read very low and high flow, all-in-one sensor
- No moving parts for greater reliability and allowing blowout for winterization with the sensor installed
- Pressure rated to 200 PSI and an operating temperature of 32 - 150 degrees Fahrenheit
- On-board LED Lights indicating power, full pipe status, relative forward flow rate, and reverse flow
- Simple setup at the controller with a standard K and Offset value for wide compatibility
Rain Bird M80132 2″ Ultrasonic Flow Sensor NPT (UFS200)
$1,299.00$1,299.00Add to cart -
- No straight-pipe requirement! Place immediately after a bend or valve, even in the same valve box (Jumbo size valve box recommended for easiest fit)
- Read very low and high flow, all-in-one sensor
- No moving parts for greater reliability and allowing blowout for winterization with the sensor installed
- Pressure rated to 200 PSI and an operating temperature of 32 - 150 degrees Fahrenheit
- On-board LED Lights indicating power, full pipe status, relative forward flow rate, and reverse flow
- Simple setup at the controller with a standard K and Offset value for wide compatibility
Rain Bird M80131 1 1/2″ Ultrasonic Flow Sensor NPT (UFS150)
$949.00$949.00Add to cart -
- No straight-pipe requirement! Place immediately after a bend or valve, even in the same valve box (Jumbo size valve box recommended for easiest fit)
- Read very low and high flow, all-in-one sensor
- No moving parts for greater reliability and allowing blowout for winterization with the sensor installed
- Pressure rated to 200 PSI and an operating temperature of 32 - 150 degrees Fahrenheit
- On-board LED Lights indicating power, full pipe status, relative forward flow rate, and reverse flow
- Simple setup at the controller with a standard K and Offset value for wide compatibility
Rain Bird M80130 1″ Ultrasonic Flow Sensor NPT (UFS100)
$879.00$879.00Add to cart -
- Includes the flow sensor in a tee, radio frequency (RF) transmitter complete with mounting kit, and RF receiver or pulse transmitter
- This signal can travel up to 2000 feet between the sensor and the display unit without the need for amplification.
- All the sensors are supplied with 20 feet of Belden type 9320 (two-conductor shield) cable.
Badger Data Industrial IR Flow Sensor 1″ Brass (8250BR1006-1211)
$849.00$849.00Add to cart -
- Includes the flow sensor in a tee, radio frequency (RF) transmitter complete with mounting kit, and RF receiver or pulse transmitter
- This signal can travel up to 2000 feet between the sensor and the display unit without the need for amplification.
- All the sensors are supplied with 20 feet of Belden type 9320 (two-conductor shield) cable.
Badger 228PV 2″ Wired Flow Sensor PVC Schedule 80 Tee Mounted (228PV2006-1211)
$639.00$639.00Add to cart -
- Includes the flow sensor in a tee, radio frequency (RF) transmitter complete with mounting kit, and RF receiver or pulse transmitter
- This signal can travel up to 2000 feet between the sensor and the display unit without the need for amplification.
- All the sensors are supplied with 20 feet of Belden type 9320 (two-conductor shield) cable.
Badger 228PV 1.5″ Wired Flow Sensor PVC Schedule 80 Tee Mounted (228PV1506-1211)
$619.00$619.00Add to cart -
The QS200 Insertion Ultrasonic Flowmeter provides an accurate reading of liquid flow rate and accumulated flow. The QS200 ultrasonic insert is available with a PVC tee or as an insert retrofit for the replacement of existing paddlewheel flow sensors.
GPI Flomec QS200 Ultrasonic Flow Meter in 3″ PVC Tee Slip 2.06 to 309 GPM 150 PSI (QS20030)
$588.00$588.00Add to cart -
- Threaded retaining nut makes it easier to service in a valve box
- The molded mounting tee provides consistent measurements and overall improved performance
- The bladed lightweight impeller is sensitive enough to measure lower flow rates
- Smart electronics capable of better signal filtering
- Affordable enough to install on nearly all new and old systems
- 2 single conductor solid copper U.L. listed #18 AWG leads with direct burial insulation
- The wiring may be extended up to 2000 ft with direct burial, twisted pair shielded cable
Weathermatic SLFSI-T 2″ Slip Type Tee Insert Wired Flow Sensor (SLFSI-T20)
$479.00$479.00Add to cart -
The QS200 Insertion Ultrasonic Flowmeter provides an accurate reading of liquid flow rate and accumulated flow. The QS200 ultrasonic insert is available with a PVC tee or as an insert retrofit for the replacement of existing paddlewheel flow sensors.
GPI Flomec QS200 Ultrasonic Flow Meter in 1″ PVC Tee Slip 0.22 to 33 GPM 150 PSI (QS20010)
$469.00$469.00Add to cart -
The QS200 Insertion Ultrasonic Flowmeter provides an accurate reading of liquid flow rate and accumulated flow. The QS200 ultrasonic insert is available with a PVC tee or as an insert retrofit for the replacement of existing paddlewheel flow sensors.
GPI Flomec QS200 Ultrasonic Flow Meter in 1½” PVC Tee Slip 0.55 to 82 GPM 150 PSI (QS20015)
$469.00$469.00Add to cart -
The QS200 Insertion Ultrasonic Flowmeter provides an accurate reading of liquid flow rate and accumulated flow. The QS200 ultrasonic insert is available with a PVC tee or as an insert retrofit for the replacement of existing paddlewheel flow sensors.
GPI Flomec QS200 Ultrasonic Flow Meter in 2″ PVC Tee Slip 0.92 to 138 GPM 150 PSI (QS20020)
$469.00$469.00Add to cart -
- Flow meter connects to Hydrawise ready controllers and Hydrawise software and shows total water use by zone
- Flow directional markings on body and Temperature range (water) – up to 100°F
- Meters are factory calibrated and allows for manual recording at the meter in gallons
- Monitors the system to alert for high- and low-flow conditions
- Electrical connection – 2 dedicated wires in shielded cable
Hunter Hydrawise HC-200-FLOW 1.98 to 132 GPM Flow Meter 2″ NPT Thread (HC200FLOW)
$449.00$449.00Add to cart -
- Threaded retaining nut makes it easier to service in a valve box
- The molded mounting tee provides consistent measurements and overall improved performance
- The bladed lightweight impeller is sensitive enough to measure lower flow rates
- Smart electronics capable of better signal filtering
- Affordable enough to install on nearly all new and old systems
- 2 single conductor solid copper U.L. listed #18 AWG leads with direct burial insulation
- The wiring may be extended up to 2000 ft with direct burial, twisted pair shielded cable
Weathermatic SLFSI-T 1.5″ Slip Type Tee Insert Wired Flow Sensor (SLFSI-T15)
$439.00$439.00Add to cart -
- Threaded retaining nut makes it easier to service in a valve box
- The molded mounting tee provides consistent measurements and overall improved performance
- The bladed lightweight impeller is sensitive enough to measure lower flow rates
- Smart electronics capable of better signal filtering
- Affordable enough to install on nearly all new and old systems
- 2 single conductor solid copper U.L. listed #18 AWG leads with direct burial insulation
- The wiring may be extended up to 2000 ft with direct burial, twisted pair shielded cable
Weathermatic SLFSI-T 1″ Slip Type Tee Insert Wired Flow Sensor (SLFSI-T10)
$419.00$419.00Add to cart