No products in the cart.
-
- Flow meter connects to Hydrawise ready controllers and Hydrawise software and shows total water use by zone
- Flow directional markings on body and Temperature range (water) – up to 100°F
- Meters are factory calibrated and allows for manual recording at the meter in gallons
- Monitors the system to alert for high- and low-flow conditions
- Electrical connection – 2 dedicated wires in shielded cable
Hunter Hydrawise HC-200-FLOW 1.98 to 132 GPM Flow Meter 2″ NPT Thread (HC200FLOW)
$449.00$449.00Add to cart -
- Threaded retaining nut makes it easier to service in a valve box
- The molded mounting tee provides consistent measurements and overall improved performance
- The bladed lightweight impeller is sensitive enough to measure lower flow rates
- Smart electronics capable of better signal filtering
- Affordable enough to install on nearly all new and old systems
- 2 single conductor solid copper U.L. listed #18 AWG leads with direct burial insulation
- The wiring may be extended up to 2000 ft with direct burial, twisted pair shielded cable
Weathermatic SLFSI-T 1.5″ Slip Type Tee Insert Wired Flow Sensor (SLFSI-T15)
$439.00$439.00Add to cart -
- 50-station capacity standard without the need for expansion modules
- Compatible with standard direct burial irrigation wire and standard irrigation wire connectors
- Decoder Auto-Address to detect and assign decoder addresses to stations automatically
- Supports up to two 2-wire paths
- Diagnostic LEDs on the backplane and each 2W-1 Decoder for advanced troubleshooting
- Upgradeable for WiFi-based remote monitoring and control via iOS and Android mobile devices (with LNK2 WiFi Module sold separately)
Rain Bird ESP-2WIRE Two-Wire 50 Station Controller Capacity, Wall Mount Plastic, F55480 (ESP-2WIRE)
$439.00$439.00Add to cart -
Flow biCoders™ ensure compatibility between virtually any third-party flow device and any Baseline controller, so retrofitting an existing site to a Baseline system is easy. Baseline controllers are equipped with powerful flow management and monitoring software to quickly react to high and low flow situations, isolate faulty zones, and protect your site from unexpected flow problems.BaseLine BL-5308 Standard Flow Sensor Meter Bicoder (BL-5308)
$429.99$429.99Add to cart -
IVM-SEN • Interfaces with LX-IVM to control weather sensors or flow sensorsRain Bird LXIVMSEN IVM-SEN 2-Wire Sensor Device (F47110)
$428.88$428.88Add to cart -
- Threaded retaining nut makes it easier to service in a valve box
- The molded mounting tee provides consistent measurements and overall improved performance
- The bladed lightweight impeller is sensitive enough to measure lower flow rates
- Smart electronics capable of better signal filtering
- Affordable enough to install on nearly all new and old systems
- 2 single conductor solid copper U.L. listed #18 AWG leads with direct burial insulation
- The wiring may be extended up to 2000 ft with direct burial, twisted pair shielded cable
Weathermatic SLFSI-T 1″ Slip Type Tee Insert Wired Flow Sensor (SLFSI-T10)
$419.00$419.00Add to cart -
Sale
- Manage up to 250 controllers
- Grant access to up to 30 contractor staff users
- One-year subscription included
- Subscription year starts upon activation day
- Includes 20 Enthusiast Plans
- 750MB data storage for irrigation files
- Card with plan code shipped to you
Hydrawise 1-Year Silver Software Subscription Plan Card, Manage 250 Controllers (Save 20%)
Original price was: $520.00.$419.00Current price is: $419.00.Original price was: $520.00.$419.00Current price is: $419.00.Add to cart -
800 automatic brass adaptor is ideal for converting existing manual valves to automatic and is designed to fit existing Superior, Champion, Lawnlife, Orbit, and Aqualine brass manual valves.Superior Model 800 Electric Valve Adaptor Brass 1 1/2in. Top Assembly (800150CH00)
$399.00$399.00Add to cart -
- Pressure regulation: 40 PSI
- Flow: 20 to 80 GPM
- Operating pressure: up to 120 PSI
- Operating temperature: up to 120°F
- Standard filter screen: 150 mesh (100 microns) SS
- Optional filter screens: 80 mesh (180 microns); 120 mesh (125 microns); SS
- Disc filter available: 120 mesh (125 microns)
Hunter ICZ Drip Control Zone Kit, 1.5″, 40 PSI 20 to 80 GPM (ICZ-151-40-XL)
$399.00$399.00Add to cart -
- Effective Flow Monitoring Even In Flows Less Than 5 GPM Effective in ranges from 1.2 GPM to 500 GPM. Teamed with the Toro TMC-424, ½”, ¾”, and 1” sensors provide a cost-effective flow monitoring and alarm system.
- Compatible With Competitive Controllers In addition to the TORO compatible controllers – TMC- 424E, TIS-PRO, Sentinel®, and SitePro® – these flow sensors work with any controller or control system compatible with frequency output flow sensors.
Toro 1″ Plastic TFS Series 1″ Flow Sensor Tee (TFS-100)
$399.00$399.00Add to cart -
-
Zones: 6
-
Expandability: Fixed
-
Operates with DC Latching Solenoids ONLY (P/N 458200)
Hunter XC Hybrid XCH-600-SS 6-Station Stainless Steel Hybrid Battery Controller (XCH600SS)
$399.00$399.00Add to cart -
-
A2C-D75 Decoder Expansion Module. Expand any ACC2 Decoder controller in 75-station increments, up to 225 stations.Hunter A2C-D75 75 Station Decoder Expansion Module for ACC2 Controller (A2CD75)
$399.00$399.00Add to cart -
• Decoder station sizes available: 1, 2, 4, 6 Max distance to decoder,14 AWG wire path: 10,000 ft. Sensor decoder available with Flow and Click inputs • Max distance to decoder, 12 AWG wire path: 15,000 ft. Max recommended distance, decoder to solenoid: 150 ft. Field programmable decoders • ICD-HP wireless handheld programmer compatible Two-way communications Surge suppression: Internal (ground wire included) • Dual pump/master valve outputs may be assigned to decoders Wire path connectors included with each decoder Number of wire paths: 6 • Automatic daily weather-based scheduling with optional Hunter Solar Sync sensorHunter ICD-600 6 Station Decoder Module for ACC/ACC2 (ICD600)
$397.00$397.00Add to cart -
- All bi-coders are fully sealed, submersion-proof, and approved for direct bury
- Shock resistant
- Freeze/heat resistant -4 to 140 degrees F
- Manufactured with 24 inches of 16 ga PVC jacketed solid core wire to connect to the two-wire and 24-inch of 18 ga PVC jacketed stranded core wire to connect to the valve wire
- Includes a built-in amperage meter that accurately measures and diagnoses valve solenoid electrical problems such as: "no current," "station short," or "over current"
- Multi-station bi-coders have color-coded wires for each station
- All bi-coders have built-in LEDs that blink during communications on the two-wire side and remain lit when power is supplied to the valve
- Run up to two typical solenoids up to 150 ft away from valve decoder using standard 14 ga irrigation wire per station wire (excluding BL-5201)
BaseLine BL-5204 Direct Burial 4-Station Bicoder Valve for Flow Sensors (BL5204)
$389.99$389.99Add to cart -
- Made from super-quality material for lasting durability
- Compatible design to suit all types
- Resistant to corrosion and abrasion for sturdiness and prolonged use
- Ergonomic design offers hassle-free use
- Service Plan Required
Hunter Cellular Communication Module CELL-KIT (4G LTE) for ICC2 Controllers (CELLKIT)
$389.00$389.00Add to cart -
- Climate Logic compatible - Automatically reschedules Rain Dial-R, Total Control-R, and KwikDial watering based on the weather
- SMRT Logic® compatible - Provide remote control from any internet-connected device
- Clear/erase memory by program - Saves time by quickly erasing only the program's desired
- Water well recovery (delay between stations) - Option of pump circuit ON or OFF
- Water Budgeting - For quick changes to the watering durations of all stations on a program at one time or pre-set a change in the water budget for each month.
- Three water day choices - Any day of the week, skip Days, or Odd/even dates. Skip Days and Odd/even dates have a day exclusion option
- Three independent programs - Allows differing watering days, start times, station run times, and station assignments
- Test All Stations program - Allows a quick test of all stations from lowest to highest number
- Master Valve/Pump Start circuit assignable per station - Stations requiring a booster pump can be supplied while other stations can run on street water pressure
- Program stack or overlap option - Allows three programs/stations on at once or restricts operations to no overlapping station runs
- RainSensor™ ready - Sensor bypass switch and terminal for sensor hookup
- Remote control ready - Compatible with CRR (Contractor Residential Remote) remote series
- 365-day calendar for Odd/Even date watering -Meets the odd/even date watering mandates often used for landscape water reductions
Irritrol Total Control R-Series 6-Station Outdoor Controller (TC-6EX-R)
$380.00$380.00Add to cart